LED R&D Lab(VD)
38
NO VIDEO
◆ Preparations before installation
※ [Caution] Be careful because if you press the switch for more than 10 seconds, the factory reset is performed.
※[Caution] Do not leave white on for more than 10 seconds.
Dehumidifying
①
②
③
⑥
3 sec
④
⑤
⑦
◇ Connect the power cable to the SET and check whether the LED is damaged and the screen display.
① After AC power is applied, press the switch on
the rear side for 1 second to release the power
standby mode. 10 seconds after the NO VIDEO
appears, press and release the switch for more
than 3 seconds.
② On the Dehumidifying screen, if you press the
Switch once more, the Factory Info window
appears. Each time you press the switch in the
factory info window, it changes in the order of
gray, dark red, dark green, and dark blue.
③ If you press and release the switch for more
than 3 seconds in the factory info window, it
moves to 'NO VIDEO'.
④ If you need a bright pattern, press and release
the switch for more than 3 seconds in the dark
pattern.
⑤ When it changes to a bright pattern, each time
the switch is pressed, it changes in the order of
white, bright red, bright green, and bright blue.
⑥ If you press and release the switch for more
than 3 seconds in a bright pattern, it moves to
'NO VIDEO'.
3 sec
Click
Click
5 sec
Click
Click
Click
3 sec
Click
Click
Click
Click
2. Preparation for Cabinet Installation
To Next Page
Loading...
