LED R&D Lab(VD)
189
10. Settings / How to Use
10-1. Control Program for PC
1. Keep LED cabinet’s Power to be not turned off
for redundancy installation.
2. Follow next steps to enable it.
A. Close LSM and move to the LSM installation path
B. Open LEDDisplayManagement_Config.xml file as Edit mode
C. Change value from 0 to 1 of <ShowAdvancedSettings> and Save it.
※ If changes are not saved due to Windows OS permission problems,
you can proceed by moving the file to the DESKTOP, editing it, and copying it back to the
original folder.
D. Run LSM again. You can see the “Power Mode” like right side.
3. If you click “On”, LED Cabinet’s power will be
always ON.
To Next Page
Loading...
