LED R&D Lab(VD)
205
Push the plastic loader as close as possible: Push the plastic load bar as close as possible to the cable.
Cut all the wires leaving about 0.5” with a wire cutter.
Ground is reinforced using drain wire. (refer to next page)
※ Without drain wire: Reinforced by contacting the connector shell as shown below using copper foil
Copper foil
Fold Al foil or Braid back and wrap it with Copper foil
Connector shell
Drain wire
• S-Box Connection
⑨ Finishing method for HDBase-T Cable
Appendix 2 - S-Box Installation and Connection
To Next Page
Loading...
