LED R&D Lab(VD)
192
10. Settings / How to Use
1. Prepare the following items.
- USB memory formatted in FAT32 format
- Copy the update file to the USB root folder
2. Insert the memory into the USB input terminal on the back of the cabinet.
(Right from the front)
- Located at the bottom right of the T-Con board (USB terminal)
3. Apply power while pressing the toggle switch on the back of the cabinet.
- Apply AC power while pressing.
- After AC power is applied, press the switch for 4 seconds to proceed
with the update.
4. After attaching and detaching power, enter the test pattern and check the
cabinet info.
- How to enter the test pattern, Refer to Page 21
※ AM3352 has different files to update to LSM/USB.
※ A separate tool is required to update the FPGA SW to USB.
L-IWAMWWAC-xxxx.x Code Release
L-IFAMWWAC-xxxx.x Code Release
10-2. Software Update – Cabinet
To Next Page
Loading...
