Samsung LH0 IWA W - CASE 2. Z-axis adjustment method

LED R&D Lab(VD)
47
CASE 2. Z-axis adjustment method
※ Adjustment method for z-axis difference between modules
`
`
`
`
`
`
Z-axis difference
1) First adjustment (if the bracket pin is fully assembled)
: Rotate the bracket pin of the module has lower Z axis level to clockwise.
Bracket pin of the module with lower Z axis
※ If bracket pin is too rotated, module can be out.
So, never rotate it over the marked position.
6~7.5mm
(-)driver
2) More adjustment (if the bracket pin of the module has higher Z-axis has been modified)
: Rotate bracket pin of the module has higher Z-axis to counterclockwise but, if Z-axis dif. remained, proceed 1) method.
※ When Bracket pin is fixed because it is fully-rotated to counterclockwise.