LED R&D Lab(VD)
202
① Input video signal to S-Box. (Input terminal: HDMI, DP)
② Check the input signal through a screen output device that can be connected to the DVI output port
(HDMI1~4, DP).
③ Connect the LAN cable from the HDBT OUT port of the S-Box to the HDBT in port of the Interface Gender.
④ Connect to the DATA IN terminal of the first cabinet using OCM Cable from the DATA OUT terminal of the
Interface Gender.
⑤ When using an input of FHD or higher, add an input signal through the Input signal Plus menu.
※ Menu – Picture – Advanced Settings – Input signal plus : Input signal selection
(Default: OFF, when the item is changed, the S-Box is rebooted.)
⑥ Displays the screen based on the cabinet at the top left.
To view the screen, connect to the HDBT OUT1 terminal of S-Box.
Connect.
⑦ S-BOX can only support screens composed of a single pitch.
• SNOWJ*U S-Box Connection
Appendix 2 - S-Box Installation and Connection
To Next Page
Loading...
