S&C Instruction Sheet 461-504 5
Safety Information
Several types of safety-alert messages may appear throughout this instruction sheet and on
labels attached to the TripSaver II Cutout-Mounted Recloser or in the TripSaver II Service Center
Conguration Software. Become familiar with these types of messages and the importance of
these various signal words:
DANGER
“DANGER” identifies the most serious and immediate hazards that will likely result in
serious personal injury or death if instructions, including recommended precautions, are
not followed.
WARNING
“WARNING” identifies hazards or unsafe practices that can result in serious personal injury
or death if instructions, including recommended precautions, are not followed.
CAUTION
“CAUTION” identifies hazards or unsafe practices that can result in minor personal injury if
instructions, including recommended precautions, are not followed.
NOTICE
“NOTICE” identifies important procedures or requirements that can result in product or
property damage if instructions are not followed.
If any portion of this instruction sheet is not understood and assistance is required, contact
the nearest S&C Sales Ofce or S&C Authorized Distributor. Their telephone numbers are
listed on S&C’s website sandc.com, or call the S&C Global Support and Monitoring Center at
1-888-762-1100.
NOTICE
Read this instruction sheet thoroughly and carefully before
configuring, installing or operating the TripSaver II Cutout-
Mounted Recloser.
If additional copies of this instruction sheet are needed, contact the nearest S&C Sales Ofce,
S&C Authorized Distributor, S&C Headquarters, or S&C Electric Canada Ltd.
It is important that any missing, damaged, or faded labels on the equipment be replaced
immediately. Replacement labels are available by contacting the nearest S&C Sales Office, S&C
Authorized Distributor, S&C Headquarters, or S&C Electric Canada Ltd.
Understanding
Safety-Alert
Messages
Following Safety
Instructions
Replacement
Instructions and
Labels
To Next Page
Loading...
Need help?
General
