S&C Instruction Sheet 461-504 3
Introduction
WARNING
Only qualified persons who are knowledgeable in the installation, operation, and
maintenance of overhead and underground electric distribution equipment, along with
all associated hazards, may install, operate, and maintain the equipment covered by this
publication. A qualified person is someone who is trained and competent in:
• The skills and techniques necessary to distinguish exposed live parts from nonlive parts
of electrical equipment
• The skills and techniques necessary to determine the proper approach distances
corresponding to the voltages to which the qualified person will be exposed
• The proper use of special precautionary techniques, personal protective equipment,
insulated and shielding materials, and insulated tools for working on or near exposed
energized parts of electrical equipment
These instructions are intended ONLY for such qualified persons. They are not intended to
be a substitute for adequate training and experience in safety procedures for this type of
equipment.
NOTICE
Thoroughly and carefully read this instruction sheet and all materials included
in the product’s instruction handbook before installing or operating the
TripSaver II Cutout-Mounted Recloser. Become familiar with the Safety Information and
Safety Precautions on pages 5 and 6. The latest version of this publication is available
online in PDF format at sandc.com/en/support/product-literature/.
This instruction sheet is a permanent part of the TripSaver II Cutout-Mounted Recloser. Designate
a location where users can easily retrieve and refer to this publication.
WARNING
The equipment in this publication must be selected for a specific application. The
application must be within the ratings furnished for the selected equipment, and can be
found in S&C Specification Bulletin 461-33.
Qualified
Persons
Read this
Instruction Sheet
Retain this
Instruction Sheet
Proper
Application
To Next Page
Loading...
Need help?
General
