S&C TripSaver II User Manual

10 S&C Instruction Sheet 461-504
Installing TripSaver
®
II Service Center Conguration Software Version 2.0
Use the following steps to install the software:
STEP 1. Double-click on the downloaded installation le to self-extract and start
the process. The name of the software and its version number will appear. Click
on the Install button to proceed, or click on the Close button to quit the
installation process. See Figure 3.
Software Installation
Figure 3. Launching the SCC v.2.0 installation.
STEP 2. After clicking on the Install button, wait for the installation to nish. The
installer will automatically install the correct .NET framework onto the
computer if .NET is missing. When .NET is successfully installed, the setup
wizard for the S&C TripSaver II Service Center Conguration Software will
open. See Figure 4 on page 11.
NOTICE
If TripSaver II Service Center Configuration Software version 1.8 or 1.9
was previously installed on the computer, the installation process will
remove it and install software version 2.0.

S&C TripSaver II Specifications

General

Brand	S&C
Model	TripSaver II
Category	Industrial Electrical
Language	English