S&C TripSaver II - Page 11

S&C Instruction Sheet 461-504 11
Installing TripSaver
®
II Service Center Conguration Software Version 2.0
Figure 4. The SCC v2.0 Installation Setup Wizard.
STEP 3. Click on the Next button to continue, or click on the Cancel button to quit the
installation process.
STEP 4. The next dialog box to open allows the installer to select the installation folder.
Click on the Change button to select a specic destination folder, or use the
default folder shown. Click on the Next button to continue, or click on the
Cancel button to quit the installation process. Click on the Back button to go
back to the previous step. See Figure 5.
Figure 5. The dialog box for selecting the destination folder.