Sanyo PLC-HF15000L - Page 30

-30-
Mechanical Disassembly
4 Main, RC rear board and Shutter removal
1 Remove 8 screws-A (M3x6) to remove the main board.
2 Remove 2 screws-B (M4x6) to remove the shutter assy.
3 Remove 1 screw-C (T3x8) to remove the RC rear board
A
C
B
Main board
RC rear board
Shutter assy
B
A
A
A
A
A
C
A
Note on mounting the Main board
After mounting the main board, confirm that the connectors
on the boards are connected firmly on the following points.
Main board
Mother board
Bridge board
Confirm connectors
on the boards are
connected firmly
Main board
Mounting
connector
A