BioPAT
®
Trace | Multi Trace Operating Instructions 51
Initial Installation
Fig. 17: BioPAT
®
Multi Trace tubing set dialysis
The connectivity cell with the built-in biosensor is supplied separately. It must
be connected at the designated points (see arrows in Figure 1) using Luer
connectors. The connection is protected from becoming mixed up by one
male and one female Luer connector.
First, connect the female Luer connector to the male Luer connector on the
tubing set.
CAUTION
Line Blockage!
When connecting the connectivity cell, it is essential to ensure that the
tubing line protruding from the male connector on the tubing set is carefully
inserted into the female connector of the connectivity cell. Otherwise, the
line may become blocked, leading to incorrect measurement results!
To Next Page
Loading...
