Sartorius Mark 3 - Page 55

Command Format Limit Description Response Format Range
GET RAMP1* “STANDARD”/”RAPID” RAMP1 STANDARD
GET RAMP2* “STANDARD”/”RAPID” RAMP2 STANDARD
GET TIME1 Float (0-99�9) 0=OFF TIME1 xx�x
GET TIME2 Float (0-99�9) 0=OFF TIME2 xx�x
GET FACTOR Float FACTOR x�xxx
GET OFFSET Float OFFSET x�xxx
GET PLACES Integer (2 or 3) PLACES x
GET SLOPE Float (0�0 - 9�99) SLOPE x�xxx
GET SLOPETIME Float (0�1 - 99�99) SLOPETIME x�xx
GET CALC “ACTUAL”/”CALC1”/
”CALC2”/”CALC3” CALC ACTUAL
GET DELAY Integer (0 - 9) DELAY x
GET STANDBY Integer (<165) STANDBY x
GET EQUILIBRATE* Integer (0 - 60) EQUILIBRATE x
GET IDEALWEIGHT Float (0�1 - 99�0) IDEALWEIGHT xx�x
GET IDEAL PERCENT Float (0�1 - 10�0) IDEAL PERCENT xx�x
GET IDEALLOCK “ON”/”OFF” IDEALLOCK ON
GET TARGETUPPER Float (0 - 100�0) TARGETUPPER xxx�x
GET TARGETLOWER Float (0 - 100�0) TARGETLOWER xxx�x
GET TARGETLIMIT “ON”/”OFF” TARGETLIMIT ON
GET MODE “STANDARD”/”SYRINGE”/
”CONCENTRATION” MODE STANDARD
GET PROGRAMNAME String PROGRAMNAME string
System Commands
SET SN xxxxxxxx Set controller SN SN M3123005A 9 characters
SET MN xxxxxxxx Set module SN MN M3123005A 9 characters
SET TCD mm/dd/yyyy TCD 12/28/2004 mm/dd/yyyy
SET BCD mm/dd/yyyy BCD 12/28/2004 mm/dd/yyyy
SET LCT EXTERNAL LCT EXTERNAL
INTERNAL LCT INTERNAL
NONE LCT NONE
SET SLEEP ON SLEEP ON
OFF SLEEP OFF
SET SLEEPTIME hh:mm pm SLEEPTIME hh:mm pm hh:mm am or hh:mm pm
SET WAKE ON WAKE ON
OFF WAKE OFF
SET WAKETIME hh:mm pm WAKETIME hh:mm pm hh:mm am or hh:mm pm
SET SLEEPDAY 1-7 SLEEPDAY 1-7 ON/OFF 1=Monday…7=Sunday
SET WAKEDAY 1-7 WAKEDAY 1-7 ON/OFF 1=Monday…7=Sunday
SET CONSERVE x CONSERVE x 0-60 minutes
SET TIME xx:xx AM/PM TIME 01:00 PM hh:mm am or hh:mm pm
SET DATE mm/dd/yyyy DATE 01/18/2005 mm/dd/yyyy
SET TIMEFORMAT 0-1 TIMEFORMAT 0 0=AM/PM, 2=24 hr
* = only for model LMA100P
55