Mark 3 Program Download Format
Introduction: This document details the program output format for the Mark 3 Moisture
Analyzer� The analyzer has the capability to transfer program settings to another Mark 3
or a PC� The analyzer can also be downloaded with settings from a PC�
This text format is used to transfer all the information necessary to control the test
conditions of a moisture analysis test�
Field Description
1 Program Number (#XXX)
2 Program Name (15 characters max�)
3 Units (0=Moisture, 1=Solids, 2=Volatiles, 3=Moisture dry, 4=PPM Moisture,
LMA100P: 5=PPM Solids, 6=Weight, 7=mg/L
LMA110S: 5=Weight, 6=mg/L
4 Slope Time (X�X minutes)
5 Slope Percentage (X�XXX)
6 Slope Calculation (0=Actual, 1=Calc 1, 2=Calc 2, 3=Calc 3)
7 Standby Temperature (165C max)
8 Equilibration Time (X minutes)
9 Ideal Weight (XX�X grams)
10 Ideal Weight % (XX�X)
11 Ideal Weight Lock (0=OFF, 1=ON)
12 Target Limit: Upper (X�XXX %)
13 Target Limit: Lower (X�XXX %)
14 Target Limit: Usage (0=OFF, 1=ON)
15 Test Resolution (2=X�XX%, 3=X�XXX%)
16 Scale Factor (X�XXX) Default=1�000
17 Scale Offset (X�XXX) Default=0�000
18 Temperature 1 (XXX)
19 Ramp 1 (0=Standard, 1=Rapid)
20 Time 1 (XX�X)
21 Temperature 2 (XXX)
22 Ramp 2 (0=Standard, 1=Rapid)
23 Time 2 (XX�X)
24 Test Mode (0=Standard, LMA100P: 1=Syringe, 2=Concentration, 3=Fat
LMA110S: 1=Concentration, 2=Fat)
25 Start Delay (seconds)
Output Example:
# 1,Default,0,1�0,0�050,0,60,0,5�0,10�0,0,100�00,0�000,0,3,1�000,0�000,105,0,0�0,0,0,
0�00,128/r/n
59
To Next Page
Loading...
Need help?
General
