To Next PageTo Next PageWhat does warning ribbon near end mean on SATO CG2 Printer?
A 'warning - ribbon near end' message on your SATO printer indicates that the remaining amount of ribbon is little. Consider ribbon replacement.
How to adjust print speed on SATO Printer?
To correct excessive print speed on your SATO printer, reduce print speed setting or adjust print speed as required.
What to do if SATO Printer shows minor error paper end?
If your SATO printer displays a 'minor error - paper end' message, it means the printer is out of paper. To resolve this, set the paper properly.
What does warning buffer near full mean on SATO Printer?
A 'warning - buffer near full' message on your SATO printer indicates that the free space for the receive buffer is low. Pause the data transmission on the host side and wait to have enough buffer space.
What to do if ribbon stock and media are mismatched in SATO CG2?
If the ribbon stock and media are mismatched in your SATO printer, consult with media supplier. Use only SATO-certified media.
How to fix program error on SATO CG2 Printer?
To fix a program error on your SATO printer caused by an incorrect program, download again.
How to resolve communication error on SATO CG2?
To resolve a communication error on your SATO printer, consider these potential causes: buffer over or RFID error. For buffer over, correct the software on the host side or set the correct protocol. For RFID error, reset the paper or set the correct protocol.
What causes hardware error in SATO CG2?
A hardware error in your SATO printer could be due to several causes: FLASH ROM error, Setting information (FROM) error, Kanji data (FROM) error, Machine error, or Head error. The suggested solution is board replacement. Alternatively, if the cause is a head error, you can replace the print head or disable the head check function.
How to fix download error on SATO CG2 Printer?
To fix a download error on your SATO printer, try downloading again. Note that there is no need to download LAN firmware to USB+RS-232C board.
What to do if print head is disconnected in SATO CG2 Printer?
If the print head of your SATO printer is disconnected, power off the printer and ensure a proper connection.
General| Print Resolution | 203 dpi (8 dots/mm) |
|---|---|
| Print Method | Thermal transfer and direct thermal |
| Print Length | Up to 39.37 inches (1000 mm) |
| Memory | 8 MB Flash |
| Media Type | Labels, tags, tickets, and continuous media |
| Media Roll Diameter | 5" (127 mm) O.D. |
| Interfaces | USB, RS232 Serial |
| Optional Interfaces | Ethernet |
| Power Source | AC 100-240V |
| Supported Barcode Types | UPC-A/E |
| Ribbon Type | Wax, wax-resin, resin |
| Operating Temperature | 41 to 104°F (5 to 40°C) |
| Storage Temperature | 14°F to 140°F (-10°C to 60°C) |
Explains pictographic symbols used for safety instructions and warnings.
Guidelines for choosing a suitable environment for printer placement.
Requirements and precautions for connecting the printer to a power source.
Details the buttons and LED indicators on the printer's control panel.
Outlines the different operational modes available for the printer.
Generates test labels for diagnostic purposes and troubleshooting.
Allows selection and configuration of printer functions like downloads and interface settings.
Explains how printer indicators signal errors and their causes/corrections.
Provides a table of common printer problems and their solutions.
Offers guidance for troubleshooting issues with different printer interfaces (USB, RS232C, LAN).
Details how to use test prints to identify and resolve print problems.
Instructions for cleaning critical printer components for optimal performance.
Technical specifications and communication settings for the RS232C serial interface.
Technical specifications and pin assignments for the USB 2.0 interface.
Specifications for LAN and Wireless LAN connectivity, including settings.
