SATO S84 - Default Initial Values

221
S84-ex/S86-ex Operator Manual
7.1 List of Initial Values
The initial value refers to the setting value of the printer when it was shipped from the factory.
If you reset the printer in default setting mode, the setting values of the printer will change back to the
factory default values. The tables below show the initial value of each setting item and the type of reset
that changes the value back to the initial value.
CAUTION
It is generally not necessary to perform the initialization. Doing so will remove all the customer settings.
7.1.1 Normal Mode
7.1.2 User Mode
7
Appendix
Setting Item Initial Value
Default
(User)
Default
(Shipping)
ADJUSTMENT MODE
PITCH POSITION Varied No No
OFFSET POSITION Varied No No
DARKNESS 50 Yes No
VOLUME LEVEL 2 Yes Yes
LCD Brightness Midrange Yes No
Setting Item Initial Value
Default
(User)
Default
(Shipping)
PRINT SPEED S84-ex 8 dots/mm: 06 IPS
12 dots/mm: 06 IPS
24 dots/mm: 03 IPS
S86-ex 8 dots/mm: 06 IPS
12 dots/mm: 06 IPS
Yes Yes
PRINT DARKNESS 06 Yes Yes
PITCH OFFSET +0.00 mm Yes Yes
CHARACTER CODE UTF-8 Yes Yes
2 BYTE FONTS GB18030 Yes Yes
2 BYTE FONTS MINCHO Yes Yes
NOTIFICATION FUNCTION SETTING NO Yes Yes
NOTICE FUNCTION CLEAN PRINTER Yes Yes