SATO S84 - Adjusting the Paper End Sensor

5 Cleaning and Performing Printer Adjustments
193
S84-ex/S86-ex Operator Manual
5.5.4 Adjusting the Paper End Sensor
This printer uses an I-mark sensor to sense the Paper end error.
The checking and adjustment procedures for the Paper end (I-mark) sensor level are as follows:
1 Go to the SENSOR LEVEL I-MARK(R)
setting screen of SERVICE MODE.
First, check the I-MARK(R) value (voltage) of the Paper end (I-mark) sensor when the
liner is placed on the sensor.
2 Open the top cover and unlock the media
feed and media sensor assembly .
3 Physically place the liner  without the
label resting over the I-mark sensor.
4 Press the media feed and media sensor
assembly  down to lock it.
To get the correct adjustment result, close the
media sensor assembly before performing the
adjustment.
5 Check if the I-MARK(R) value is 2.0 V or
lower.
If not, change ADJUST LEVEL using the /
buttons until the I-MARK(R) value is 2.0 V or lower.
1
2
I-mark sensor
I-MARK(R) level: ≤ +2.0V