SATO S84 - Adjusting the Print Position

5 Cleaning and Performing Printer Adjustments
178
S84-ex/S86-ex Operator Manual
5.3.2 Adjusting the Print Position
Print position is adjustable within the range of +3.75 mm to -3.75 mm (+0.15” to -0.15”) in the adjustment
mode described above. The shift experienced by the media, ribbon or print layout can be offset with the
adjustment of the pitch position.
Note
The above base reference point (print position) will be the stop position when the sensor type is set to Gap
sensor.
Adjust the print position using the following procedure:
1 When the printer is in online mode, press
the LINE button to change the printer to
offline mode.
Adjustment Location Adjustment Range
Adjustment Mode: Pitch Position +3.75 mm to -3.75 mm
(+0.15” to -0.15”)
-3.75 mm (-0.15”) ~ +3.75 mm (+0.15”)
Media feed direction
Print position
(Print head)
Adjustment for
“+” value
No
adjustment
Adjustment for
“-” value
Gap sensor