6 Troubleshooting
210
S84-ex/S86-ex Operator Manual
a
6.2
When a Warning Message Occurs
When a warning message is shown on the screen, the printer continues issuing media.
The warning message, its cause and the countermeasures are as follows:
Warning
No.
Message LED/Buzzer Cause Countermeasure
01
Label near end
Lights blue.
No beep sound.
To clear the error:
Open and close the
print head.
The remaining amount of
media is not enough.
Replace the media.
Refer to Section 3.5
Loading Media for
details.
02
Ribbon near end
Lights blue.
No beep sound.
To clear the error:
Open and close the
print head.
The remaining amount of
ribbon is not enough.
Replace the ribbon.
Refer to Section 3.2
Loading the Ribbon for
details.
03
Receive buffer is
nearly full
Lights blue.
No beep sound.
Available space for
receive buffer is low.
Do not send data from the
host until the analysis of
received data is
completed.
04
Command error
Lights blue.
One short beep.
To clear the error:
The icon will be
cleared by receiving
the next item or
canceling the job.
Command error has been
detected.
Check the print data.
05
Head error
Lights blue.
No beep sound.
A head check error is
detected when
“NORMAL” has been
selected for the HEAD
CHECK setting screen.
Change the HEAD
CHECK setting to
“BARCODE” and continue
the print job.
Replace the print head.
Refer to Section 7.7.1
Replacing the Print
Head for details.
To Next Page
Loading...
