7 Appendix
276
S84-ex/S86-ex Operator Manual
7.12.2
LAN Ethernet Interface
Basic Specifications
Connector RJ-45 Receptacle
Power Supply Powered from the printer
Protocol Status3
Status4 (Cyclic response mode)
Status4 (ENQ response mode)
Status5
IP Address 0.0.0.0 - 255.255.255.255
Initial: 192.168.1.1
Subnet Mask 0.0.0.0 - 255.255.255.255
Initial: 255.255.255.0
Gateway Address 0.0.0.0 - 255.255.255.255
Initial: 0.0.0.0
Link/Status LED
LED Color Description
LED1 Green LED lights up for 10 ms when packets are
received. LED lights up when the printer
established the LINK with Ethernet device.
LED2 Orange
LED lights off when the printer detected the
connection to 10BASE-T.
LED lights up when the printer detected the
connection to 100BASE-TX.
LED lights up when a cable is not connected.
Cable Specifications
Cable 10BASE-T/100BASE-TX Category 5
Cable Length 100 m (328 feet) or less
Software Specifications
Supported Protocol TCP/IP
Network Layer ARP, IP, ICMP
Session Layer TCP, UDP
Application Layer LPD, FTP, TELNET, BOOTP, DHCP, HTTP, SNMP, SNTP
To Next Page
Loading...
