SATO S84 - Advanced Mode

7 Appendix
225
S84-ex/S86-ex Operator Manual
7.1.5 Advanced Mode
Setting Item Initial Value
Default
(User)
Default
(Shipping)
PRINTER TYPE DISPENSER Yes Yes
BACKFEED MOTION BEFORE Yes Yes
PRINT METHOD TRANSFER (Set to DIRECT with direct
thermal model)
Yes Yes
PITCH SENSOR ENABLE (When CONTINUOUS is
selected)
Yes Yes
SENSOR TYPE GAP Yes Yes
COMMAND ERROR DISABLE Yes Yes
HEAD CHECK DISABLE Yes Yes
HEAD CHECK NORMAL (When HEAD CHECK is
enabled)
Yes Yes
HEAD CHECK MODE ALL (When HEAD CHECK is enabled) Yes Yes
HEAD CHECK PAGE NO. 000001 (When CHECK PAGE is
selected)
Yes Yes
EXTERNAL SIGNAL SETTING NO - -
EXTERNAL SIGNAL ENABLE Yes Yes
EXTERNAL SIGNAL TYPE4 Yes Yes
EXTERNAL REPRINT DISABLE Yes Yes
CONTINUOUS PRINT DISABLE Yes Yes
ENHANCED REPRINT DISABLE Yes Yes
I/O SIGNAL SETTING NO - -
INPUT SIGNAL
PRINT START 20Pin Yes Yes
REPRINT 8Pin Yes Yes
LABEL NEAR 7Pin Yes Yes
FEED 21Pin Yes Yes
OUTPUT SIGNAL
PAPER END 17Pin Yes Yes
RIBBON END 16Pin Yes Yes
MACHINE ERR 4Pin Yes Yes
PRINT END 5Pin Yes Yes
ONLINE 6Pin Yes Yes
RIBBON NEAR 18Pin Yes Yes
DECIDED? NO - -