SBC PCD3 Series - Battery Change for PCD3.M3 xx0 with PCD3.R010

Saia-Burgess Controls AG
Hardware manual for PCD3 series │ Document 26-789 ENG19│ 2018-06-29
Battery change at the PCD3.M3xx0 with PCD3.R010
Maintenance
8-3
8
8.2 Battery change at the PCD3.M3xx0 with PCD3.R010
Theresources(registers,ags,timers,counters,etc.)andpartly,alsotheuser
program and texts/DBs, are stored in the RAM. To ensure that they do not get lost
during a power failure and (if any) the hardware clock continues to run, the PCD3
isequippedwithabu󰀨ercapacitor(SuperCap)orabu󰀨erbattery:
- For new controllers, the batteries are included in the package and must be used
during commissioning. Note the polarity of the batteries:
- Insert button batteries Renata CR 2032 so that the positive pole is visible
The CPU with lithium batteries are not maintenance free. The battery voltage is
monitored by the CPU.
The LED BATT lights up and the XOB 2 is activated when:
● the battery voltage is below 2.4 V or higher than 3.5 V
● the battery is discharged or has an interruption
● the battery is missing
We recommend changing the battery while the Saia PCD
®
is live, so no data loss
occurs.
Ordering information:
Type Description
PCD3.R010 BatterymoduleforPCD3.M3xxx,plug-inontoI/OSlot#3
4 507 4817 0
Lithium battery for PCD processor units
(RENATA button type CR 2032)
2)
2
) Shelf life 1…3 years. Depending on the ambient temperature, the higher the temperature, the shorter the
bu󰀨eringtime