SBC PCD3 Series - Insertion of I;O Modules

Saia-Burgess Controls AG
Hardware manual for PCD3 series │ Document 26-789 ENG19│ 2018-06-29
Installation of the CPU and module carrier
PCD3.Mxxx0 Classic CPU and expansion enclosure
3-22
3
3.7.3 Insertion of I/O modules
 Label holder
Lock snap
Guiding groove

PCD3
with 4 module places
Additional
protection
with screw


Insert the module in the appropriate module slot and press until the bottom
of the housing of the CPU or the module carrier is reached. Make sure that
the orange latch is engaged

For safety, a guide groove is provided to prevent the module from being
insertedthewrongwayround.Indi󰀩cultenvironmentalconditions,the
modules can be additionally secured with a screw. Screw type: self-tapping
3 × 8 mm, standard type available in the metal trade

Number of module slots in the module carrier:
● 4 places (labeling 0, 1, 2 and 3) PCD3.Mxxx0, C100 / C200 / T760
● 2 places (label 0 and 1). The PCD3.C110 can only be used as the last
module carrier in the bus