Schäfer iQdata RMS 222 - Page 76

Page 76 of 86 SCHÄFER IT-Systems
Industriestraße 41  D-57518 Betzdorf
Phone: +49 (0) 2741/283-770  sales@schaefer-it-systems.de  www.schaefer-it-systems.de As
amended on 16/8/2019 (subject to technical changes)
User Manual
The following macros are available:
Example: If the text has the following form:
When the logic is triggered and the notification is sent, the recipient sees a message in the following form:
Available macros
%1
Description of the logic diagram that triggered
Example:
If
the 'on-board temperature' (id = 201001) is in the 'alarm' state.
then
device5 '(id = 601001) immediately changes the status to' on '.
%2
Description of all sensors in the logic diagram and their sensor status when the logic is triggered.
Example:
Onboard temperature '(id = 201001) in the' normal 'state.
Temperature2 '(id = 201002) in the' normal 'state.
%3
Response time of the logic diagram
Example:
08:16:46 2018/09/ 05
%4
Name of the logic diagram
Example:
'Logic diagram 3'.
%5
Name of the sensor that triggered the logic diagram
%6
State of the sensor in the logic diagram that triggered the logic at the moment
%7
Value measured by the sensor that triggered the logic diagram at the time
%8
Sensor ID that triggered the operation of the logic circuit.