List of Setup Parameters VC 1100
Version 2 → parqalist/VC1100E
5-42 C01 / C02 - C11 / C12 © Schenck VIBRO GmbH, D-64273 Darmstadt, Juni 98
Limit Configuration - Group M
M01 Channel A: Monitoring Y [ ] N [ ]
M02 Channel B: Monitoring Y [ ] N [ ]
M03 Channel A: Monitor lim_1 Y [ ] N [ ]
M04 Channel B: Monitor lim_1 Y [ ] N [ ]
M05 Channel A: Monitor lim_2 Y [ ] N [ ]
M06 Channel B: Monitor lim_2 Y [ ] N [ ]
M07 Channel A: Monitor lim_b Y [ ] N [ ]
M08 Channel B: Monitor lim_b Y [ ] N [ ]
M09 Channel A: Value lim_1 [______________]
M10 Channel B: Value lim_1 [______________]
M11 Channel A: Value lim_2 [______________]
M12 Channel B: Value lim_2 [______________]
M13 Channel A: Value lim_b [______________]
M14 Channel B: Value lim_b [______________]
M15 Channel A: Delay Time lim_1 [______________]
M16 Channel B: Delay Time lim_1 [______________]
M17 Channel A: Delay Time lim_2 [______________]
M18 Channel B: Delay Time lim_2 [______________]
M19 Channel A: Delay Time lim_b [______________]
M20 Channel B: Delay Time lim_b [______________]
Relay Configuration - Group N
N01 Channel A: lim_1 assigned to -- [ ] K1 [ ] K2 [ ] K3 [ ]
N02 Channel B: lim_1 assigned to -- [ ] K1 [ ] K2 [ ] K3 [ ]
N03 Channel A: lim_2 assigned to -- [ ] K1 [ ] K2 [ ] K3 [ ]
N04 Channel B: lim_2 assigned to -- [ ] K1 [ ] K2 [ ] K3 [ ]
N05 Channel A: lim_b assigned to -- [ ] K1 [ ] K2 [ ] K3 [ ]
N06 Channel B: lim_b assigned to -- [ ] K1 [ ] K2 [ ] K3 [ ]
N07 Relay K1: Latching Y [ ] N [ ]
N08 Relay K2: Latching Y [ ] N [ ]
N09 Relay K3: Latching Y [ ] N [ ]
N10 Relay K1: Normally Energized Y [ ] N [ ]
N11 Relay K2: Normally Energized Y [ ] N [ ]
N12 Relay K3: Normally Energized Y [ ] N [ ]
N13 Relay K1: Logic AND [ ] OR [ ]
N14 Relay K2: Logic AND [ ] OR [ ]
N15 Relay K3: Logic AND [ ] OR [ ]
OK Monitoring - Group O
O01 Channel A: OK-Monitoring Y [ ] N [ ]
O02 Channel B: OK-Monitoring Y [ ] N [ ]
O03 Channel A: OK-Lower Limit [______________]
O04 Channel B: OK-Lower Limit [______________]
O05 Channel A: OK-Upper Limit [______________]
O06 Channel B: OK-Upper Limit [______________]
Baud Rate for Serial Interface - Group P
P00 Device Address [______________]
P01 Serial Port 1: 9600 [ ] 4800 [ ] 2400 [ ] 1200 [ ]
P02 Serial Port 2: 9600 [ ] 4800 [ ] 2400 [ ] 1200 [ ]
To Next Page
Loading...