Schenck Vibrocontrol 110 C01 - Display Measured Values; Relay status

VC 1100 Built-in Operating Panel and Display
VC1100E/bult-in Version 2 →
© Schenck VIBRO GmbH, D-64273 Darmstadt, November 97 C01 / C02 - C11 / C12 4-7
Display Measured Values
Access all modes from the main menu. Exit a mode and return to
the main menu by pressing . If the display is dark, press any
key to turn it on.
Main menu appears.
Signal detection type
Unit
Measured value
Channel
The display shows vibration level of channel A.
A flashing display indicates a limit value was exceeded.
Step to next measured values:
− Bearing condition channel A
− Vibration level channel B
− Bearing condition channel B
Relay status
Relay identification
Event
or