Built-in Operating Panel and Display VC 1100
Version 2 → built-in/VC1100E
4-6 C01 / C02 - C11 / C12 © Schenck VIBRO GmbH, D-64273 Darmstadt, November 97
Quick Reference to the Change Setup Parame-
ters Mode
The start is always made from the main menu.
Enter the "Change Setup Parameters" mode
Select the parameter you want to change.
Access the change parameter value mode
Change the parameter value.
Save the new parameter value.
Change other parameters or press to return to the main me-
nu.If the new setup is consistent, it is accepted and it becomes the
current setup and the main menu appears.
If not, an error message will appear (see previous page).
The consistency check takes about 15 s. During this time the mo-
nitoring function is suspended.
To Next Page
Loading...