VC 1100 Built-in Operating Panel and Display
VC1100E/bult-in Version 2 →
© Schenck VIBRO GmbH, D-64273 Darmstadt, November 97 C01 / C02 - C11 / C12 4-3
Change Setup Parameters
Access all modes from the main menu.
Exit a mode and return to the main menu by pressing
If the display is dark, press any key to turn it on.
The main menu appears.
Parameter value
Parameter number
Parameter group
Hold the key DOWN, then press key.
A cursor that underlines the parameter group indicates that the pa-
rameter group and number can be changed.
Step to the next parameter number using the
and
keys.
Pressing this key at this time has no effect, since I01 is the first
parameter.
Step to the next parameter number.
Reach any parameter by pressing either the up or down arrow
keys. Press and release the key to go to the next parameter
(single step). Press and hold the key if you want to scroll through
the parameter numbers faster. The longer you hold a key down,
the faster the parameter numbers change.
The last parameter is P02.
Access the change parameter value mode by pressing
.
or
To Next Page
Loading...