Schenck Vibrocontrol 110 C01 - Parameter Configuration

VC 1100 List of Setup Parameters
VC1100E/paralist Version 2 →
© Schenck VIBRO GmbH, D-64273 Darmstadt, Juni 98 C01 / C02 - C11 / C12 5-41
Parameter Configuration
Plant :________________________________________________________________________
Version :___VC 1100/C ___V _______________________________________________________
Name :_____________________________________________________Date:_______________
Channel and Pickup Selection - Group I
I01 Channel A Y [ ] N [ ]
I02 Channel B Y [ ] N [ ]
I03 Pickup a [ ] v [ ]
I04 Unit mV/g [ ] mV/m/s2 [ ] mV/mm/s [ ] mV/ips [ ]
I05 Sensitivity [______________]
I06 Frequency response linearization Y [ ] N [ ]
Channel Configuration - Group J
J01 Channel A: Vibration Y [ ] N [ ]
J02 Channel B: Vibration Y [ ] N [ ]
J03 Channel A: Parameter a [ ] v [ ] s [ ]
J04 Channel B: Parameter a [ ] v [ ] s [ ]
J05 Channel A: Unit g [ ] m/s2 [ ] mm/s [ ]
ips [ ] mm [ ] mils [ ]
J06 Channel B: Unit g [ ] m/s2 [ ] mm/s [ ]
ips [ ] mm [ ] mils [ ]
J07 Channel A: Signal Detection rms [ ] pc [ ] ppc [ ]
J08 Channel B: Signal Detection rms [ ] pc [ ] ppc [ ]
J09 Channel A: Full Scale [______________]
J10 Channel B: Full Scale [______________]
J11 Channel A: Bearing Condition (BCU) Y [ ] N [ ]
J12 Channel B: Bearing Condition (BCU) Y [ ] N [ ]
J13 Channel A: BCU Full Scale [______________]
J14 Channel B: BCU Full Scale [______________]
J15 Channel A: BCU Averaging (BCU) Y [ ] N [ ]
J16 Channel B: BCU Averaging (BCU) Y [ ] N [ ]
J17 Channel A: Mean time (BCU) [______________]
J18 Channel B: Mean time (BCU) [______________]
J19 Channel A: BCU Scaling Factor [______________]
J20 Channel B: BCU Scaling Factor [______________]
Filter Configuration - Group K
K01 Channel A: Low cutoff frequency 1Hz [ ] 3Hz [ ] 10Hz ISO [ ] * Spec. [ ]
K02 Channel B: Low cutoff frequency 1Hz [ ] 3Hz [ ] 10Hz ISO [ ] * Spec. [ ]
K03 Channel A: High cutoff frequency 10kHz [ ] 1kHz ISO [ ] * Spec. [ ]
K04 Channel B: High cutoff frequency 10kHz [ ] 1kHz ISO [ ] * Spec. [ ]
Analog Output - Group L
L01 Analog Output 1: 0..10V [ ] 0..20mA [ ] 4..20mA [ ]
L02 Analog Output 2: 0..10V [ ] 0..20mA [ ] 4..20mA [ ]
L03 Analog Output 1: Parameter vib_A [ ] BCU_A [ ] vib_B [ ] BCU_B [ ]
L04 Analog Output 2: Parameter vib_A [ ] BCU_A [ ] vib_B [ ] BCU_B [ ]
L05 Analog Output 1: Full Scale [______________]
L06 Analog Output 2: Full Scale [______________]
∗ Possible only if a supplementary filter is installed as an option.