Schenck Vibrocontrol 110 C01 - Measuring Ranges

VC 1100 Overview
VC1100E/overview Version 2 →
© Schenck VIBRO GmbH, D-64273 Darmstadt, November 97 C01 / C02 - C11 / C12 1-5
Measuring Ranges
The measuring ranges are microprocessor controlled and can be
selected continuously within the limits defined in the following
table:
Transducer : Vibration acceleration pick-up
Signal detection : Root mean sqare value
Measured Parameter Measuring Range Unit
Min Max
Vibration
Acceleration
0 ... 4.00
0 ... 0.40
0 ... 800
0 ... 80.0
m/s
2
g
Vibration Velocity 0 ... 5.00
0 ... 0.20
0 ... 999
0 ... 40.0
mm/s
ips
Transducer : Vibration Velocity pick-up
Signal detection : Root mean sqare value
Measured Parameter Measuring Range Unit
Min Max
Vibration Velocity 0 ... 5.00
0 ... 0.20
0 ... 150
0 ... 6.00
mm/s
ips
Vibration
Displacement
0 ... 50.0
0 ... 2.00
0 ... 333
0 ... 13.3
µm
mils
Multiply values by 1.41 for peak-values and by 2.82 for peak-to-
peak values. The largest acceptable number is 999.
The measuring ranges for BCU-Monitoring are independent of the
measuring ranges for vibration monitoring.
Measured Parameter Measuring Range Unit
Min Max
Bearing Condition 0 ... 1.00 0 ... 140 BCU