Schenck Vibrocontrol 110 C01 - Relay Configuration Group N

VC 1100 List of Setup Parameters
VC1100E/paralist Version 2 →
© Schenck VIBRO GmbH, D-64273 Darmstadt, Juni 98 C01 / C02 - C11 / C12 5-27
Relay Configuration Group N
General
VIBROCONTROL 1100 provides three relays to indicate alarm
level exceedances. The relays are designated as K1, K2 and K3.
Relay operation can be defined as follows:
Fig. 5 - 7 : Parameter Group N, Relais Configuration
Programmable Relay Operation:
1. Which alarm level exceedance controls which relay?
2. Latching or non-latching operation?
3. Normally energized or normally de-energized operation?
4. Logical combinations.
Comments to item 1:
It is common to assign alarm levels lim_1 of channel A and B to
relay K1 and alarm levels lim_2 of channel A and B to relay K2.