Overview VC 1100
Version 2 → overview//VC1100E
1-14 C01 / C02 - C11 / C12 © Schenck VIBRO GmbH, D-64273 Darmstadt, November 97
Inputs and Outputs
Inputs
VIBROCONTROL 1100 accepts vibration velocity transducers or
accelerometers.
In 2 channel operation, pickups of the same type with the same
sensitivity are required.
Accelerometers (passive transducers) are powered by the internal
power supply of VIBROCONTROL 1100.
Outputs
a) Alarm Indication
Alarm level exceedances are indicated by galvanically free relay
contacts.
b) Analog-Outputs
Two separate analog outputs are provided for analog meters or
strip chart recorders. Which measured parameter is supplied on
which analog output is determined during the setup. Each analog
output can be configured for either 0 ... 10 V or 0.4 ... 20 mA.
Remote I/O (Serial Interface)
Up to 205 VIBROCONTROL 1100 can be daisy-chained to one
serial interface of a computer or process controller. Status, Log
Book, and measured values can be read, stored, displayed,
printed, etc.
In addition the configuration of each VIBROCONTROL 1100 can
be confirmed and modified.
To Next Page
Loading...