Schenck Vibrocontrol 110 C01 - List of Setup Parameters

To Next Page

To Previous Page

VC 1100 List of Setup Parameters

VC1100E/paralist Version 2 →

5 List of Setup Parameters

Basic Concepts

VIBROCONTROL 1100 stores its setup parameters in non-volatile

memory. The operating system uses this data to configure the

analog circuits and the software modules. All data is uniquely na-

med. We call this data "Setup Parameters" or simply "Parameters"

and reference them by name. The setup parameter values can ea-

sily be changed within predefined ranges, providing a convenient

way to configure the measuring and monitoring system.

VIBROCONTROL 1100 checks the consistency of the setup after

leaving the "Change Setup Parameters" mode. If the setup is in-

consistent, the display shows an error messages. The setup must

be corrected since the VIBROCONTROL 1100 will not accept an

inconsistent setup.

Parameter list structure

Parameters are listed in sequence with a complete definition. The

definition describes its function, choices, and range.

The same format is used for all parameters.

Example:

Group

Number

Title

K 01 Channel A: Lower Frequency Corner

Choices: 1 Hz, 3 Hz, 10 Hz ISO

Function: Select the lower frequency corner for channel A

Parameter specifier

All setup parameters are organized in functional groups. The

"Parameter Specifier" consists of a group and a number within the

group. The first character specifies the group and the two digit

number specifies the individual parameter.