Connectors and Interfaces VC 1100
Version 2 → connect/VC1100E
3-12 C01 / C02 - C11 / C12 © Schenck VIBRO GmbH, D-64273 Darmstadt, November 97
c) A HOST Communicating with Several
VIBROCONTROL 1100
The HOST can control up to 205 daisy-chained VIBROCONTROL
1100's with one serial interface on the HOST.
Each VIBROCONTROL 1100 has a unique address.If a VIBRO-
CONTROL 1100 does not receive it's unique address, it passes
the message to the next unit. If one unit is removed, the daisy-
chain must be closed as shown in figure 10.
For more information, please consult the "Remote I/O" chapter in
this manual.
Fig. 3 - 11: Interfacing a HOST with several VC-1100’s
Use commercially available shielded data transfer cables with two
twisted pairs.
To Next Page
Loading...