Schenck Vibrocontrol 110 C01 - Analog Outputs Group L; General

VC 1100 List of Setup Parameters
VC1100E/paralist Version 2 →
© Schenck VIBRO GmbH, D-64273 Darmstadt, Juni 98 C01 / C02 - C11 / C12 5-19
Analog Outputs Group L
General
VIBROCONTROL 1100 provides two analog outputs. Select which
measured parameter issent to analog output 1 and 2.
The full scale values selected in setup parameters J09/J10 and
J13/J14 determine the analog output calibration.
Fig. 5 - 5: Parameter Group L, Analog Outputs
You cannot select BCU values if a vibration velocity transducer is
used. The consistency check will generate error message: -65.
L 01 Analog Output 1 : Signal Range
Choises : 0 ... 10 V, 0 ... 20 mA, 4 ... 20 mA
Function : Select signal type.
L 02 Analog Output 2 : Signal Range
Choises : 0 ... 10 V, 0 ... 20 mA, 4 ... 20 mA
Function : Select signal type.