Schenck Vibrocontrol 110 C01 - Parameter Title; Parameter Groups

List of Setup Parameters VC 1100
Version 2 → parqalist/VC1100E
5-2 C01 / C02 - C11 / C12 © Schenck VIBRO GmbH, D-64273 Darmstadt, Juni 98
Parameter Title
The "Parameter Title" is a short description of the parameter's
function.
Parameter Groups
Group I Channel and Pickup Selection
Define measuring channels
Pickup type and sensitivity
Group J Channel Configuration
Define measured parameters, units, signal detection
type, and full scale.
Group K Filter Configuration
Define upper and lower frequency corners.
Group L Analog Outputs
Assign measured parameters and define signal
type.
Group M Limit Configuration
Define monitoring functions,
limit values and delay times.
Group N Relay Configuration
Assign limit values to relays. Define relay operation.
Group O OK Monitoring
Enable/Disable
Group P Serial Interface
Define device address and baud rate.
Group S Service Functions
Check relay operation.
Set analog outputs to predefined levels.
Run self-test and
Self-calibration.