Schenck Vibrocontrol 110 C01 - Channel and Pickup Selection Group I; General

VC 1100 List of Setup Parameters
VC1100E/paralist Version 2 →
© Schenck VIBRO GmbH, D-64273 Darmstadt, Juni 98 C01 / C02 - C11 / C12 5-5
Channel and Pickup Selection Group I
General
Configure VIBROCONTROL 1100 as a Single- or Dual-channel
monitor. Use channel A or channel B in the Single-channel mode.
In the Dual-channel mode, VIBROCONTROL 1100 only accepts
pickups of the same type and sensitivity.
Fig. 5 - 2: Parameter Group I, Channel Selection
I 01 Channel A
Choices : Y, N
Function : Enable or disable Channel A.
Y = Yes Channel A is active
N = No Channel A is not active
I01 = Y : For measured value acquisition, connect a pickup to
channel A.
I01 = N : Disables all measuring and monitoring functions for
channel A.