Built-in Operating Panel and Display VC 1100
Version 2 → built-in/VC1100E
4-16 C01 / C02 - C11 / C12 © Schenck VIBRO GmbH, D-64273 Darmstadt, November 97
Error Messages
VIBROCONTROL 1100 automatically checks for setup consisten-
cy upon exiting the "Change Setup Parameters" mode. If the setup
is not consistent, an error message is displayed.
The consistency check stops at the first inconsistency detected. It
assumes that the parameter with the lowest number is correct.
Therefore, a parameter other than the one displayed could be the
cause of the inconsistency.
A list of error messages appears on the next page.
To Next Page
Loading...