Schenck Vibrocontrol 110 C01 - Remote I;O; a) A HOST communicating with one VC-1100; b) A HOST communicating with one VC-1100

To Next Page

To Previous Page

VC 1100 Connectors and Interfaces

VC1100E/connect Version 2 →

Remote I/O

VIBROCONTROL 1100 has two RS-232C serial interfaces. Hard-

ware handshakes are not required for communication with process

controllers or personal computers (HOST). This reduces the num-

ber of cable conductors required.

Cables should be shielded with two twisted pairs. The Remote In-

terface provides a means to interrogate and modify the configura-

tion as well as obtain the measured values from up to 205 daisy-

chained VIBROCONTROL 1100's.

VIBROCONTROL 1100 can be connected to a HOST in two diffe-

rent ways:

a) A HOST communicating with one VC-1100

for 25-pole Sub-D Plug

Fig. 3 - 9: Interfacing a HOST with one VC-1100

b) A HOST communicating with one VC-1100

for 9-pole Sub-D Plug

RD = Receive Data

(receive)

TD = Transmit Data

(send)

SG = Signal Ground

(Ground)

Fig. 3 - 10: Interfacing a HOST with one VC 1100