Built-in Operating Panel and Display VC 1100
Version 2 → built-in/VC1100E
4-20 C01 / C02 - C11 / C12 © Schenck VIBRO GmbH, D-64273 Darmstadt, November 97
How to react to error-messages?
The 2nd column of the above list of error-messages contains the
characters „k“ „r" „!" 2e" and „w". These characters show what
to do if the corresponding error message occurs.
Repeat the command.
If VIBROCONTROL 1100 repeats this error-message after several
retries, there is a severe problem and the instrument must be sent
to SCHENCK for repair.
Send VIBROCONTROL 1100 to SCHENCK for repair.
This error activates the OK-relay temporarily, because an automa-
tic restart is performed.
Sporadic occurrence of this error indicates that external noise ef-
fects the unit. Check installation, especially shielding of cab-les
and grounds.
Permanent occurrence of this error indicates a severe fault. Send
unit to SCHENCK for repair.
Re-do configuration or download consistent setup. If this is not
successful, send unit to SCHENCK for repair.
Repeat command using correct data.
k
r
!
e
w
To Next Page
Loading...