Schenck Vibrocontrol 110 C01 - Bearing condition (BEARCON)

List of Setup Parameters VC 1100
Version 2 → parqalist/VC1100E
5-10 C01 / C02 - C11 / C12 © Schenck VIBRO GmbH, D-64273 Darmstadt, Juni 98
Measuring range
Pickup Unit rms pc ppc
min max min max min max
m/s
2
0... 4.00 0... 800 0... 6.00 0... 999 0... 12.0 0... 999
a g 0... 0.40 0... 80.0 0... 0.60 0... 120 0... 1.20 0... 240
mm/s 0... 5.00 0... 999 0... 7.50 0... 999 0... 15.0 0... 999
ips 0... 0.20 0... 40.0 0... 0.30 0... 60.0 0... 0.60 0... 120
mm/s 0... 5.00 0... 150 0... 7.50 0... 225 0... 15.0 0... 450
v ips 0... 0.20 0... 6.00 0... 0.30 0... 9.00 0... 0.60 0... 18.0
mm 0... 50.0 0... 333 0... 75.0 0... 500 0... 150 0... 999
mils 0... 2.00 0... 13.3 0... 3.00 0... 20.0 0... 6.00 0... 40.0
Bearing condition (BEARCON)
a BCU 0... 1.00 0...140
Fig. 5 - 4: Parameter Group J, Signal Detection Type