VC 1100 Overview
VC1100E/overview Version 2 →
© Schenck VIBRO GmbH, D-64273 Darmstadt, November 97 C01 / C02 - C11 / C12 1-13
System messages such as:
– no calibration data in EEprom
– no dialog data in EEprom
will cause an OK-error which can be reset by means of Relay
Reset.
Important:
When an OK error occurs, all limit relays maintain their current
status. After removing the OK error and acknowledging it by
"Relay Reset", they perform their normal function again.
In case of a system error message, e.g.
– calibration data not readable (ER -31)
– no valid calibration data in the EEPROM (ER -37)
a hardware error is present.
This error can only be eliminated by a Schenck service station or
in the parent company.
To Next Page
Loading...