VC 1100 Built-in Operating Panel and Display
VC1100E/bult-in Version 2 →
© Schenck VIBRO GmbH, D-64273 Darmstadt, November 97 C01 / C02 - C11 / C12 4-5
Confirm the error messages by pressing any key. The program will
automatically show the inconsistent parameter.
Correct the error:
Press
Adjust parameter value:
Accept parameter value by pressing
.
Exit to main menu
.
If the setup is consistent, the program returns to the main menu.
If not, the display shows the next error message. Correct this error
and repeat the procedure until the setup is consistent. Find ex-
planations of error messages on pages 15 of this chapter
Escape from the change parameter value mode by pressing .
Indicates:
Parameter value is selectable
Indicates:
Parameter numbermode is
selectable
Press to return to the select parameter number mode.
Press
again to return to the main menu.
To Next Page
Loading...