Installation manual
HB-37420-810-01-25F-EN PSC1-C-100 Installation manual - V2.2.docx Page 102 of 201
Version: 25F
5.6 Installation of I/O expansion
Note:
Max. eight PSC1-E-13x modules can be operated using a basic device.
5.6.1.1 Physical address configuration for the slave modules (central/decentral)
The bus address must be set on the PSC1-E-13x modules with the aid of the address switch.
The address is set on the rear panel depending on the slot (mounting position) of the module.
Note:
• Address range on the PSC1-E-13x module is 1…8.
• Address "0" is reserved for the basic device.
• Factory setting of all expansion modules: 1
To Next Page
Loading...
