schmersal PSC1 - Transport;Storage

Installation manual
HB-37420-810-01-25F-EN PSC1-C-100 Installation manual - V2.2.docx Page 14 of 201
Version: 25F
3.5 Transport/storage
The instructions on transport, storage and correct handling are to be followed.
The climatic specifications as per the sec. "Technical data" are to be met.
Device types
The series PSC1-C-100 comprises
- The basic devices PSC1-C-100 optionally with
o Integrated communication modules
 Standard fieldbus PSC1-C-100-FBx
(1)
) or
 Safe fieldbus PSC1-C-100-FB x
(1)
)-y
(1)
These options usually have an SD memory card slot on board as a minimum.
o Integrated SD memory card slot
 PSC1-C-100-MC
- The central I/O expansion modules PSC1-E-131-… and PSC1-E-133-…
- The decentral I/O expansion modules PSC1-E-37-…
- The central axis expansion modules PSC1-E-21-SDM1, PSC1-E-22-SDM1-2, PSC1-E-23-
SDM2 and PSC1-E-24-SDM2-2
Basic devices
The series PSC1-C-100 series is a modular safety controller. The device is freely programmable
for the safe processing of EMERGENCY STOP buttons, two-hand controls, light barriers, operating
mode selector switches, etc. and also drive-related safety functions. For the safety-related signal
processing, pre-configured blocks are available for a large number of input devices. The same
applies for safety functions for drive monitoring. You will find details in the programming manual.
In the basic version the device has 14 safe inputs and up to 25/23 safe 2-channel shutdown
channels. (4x PP or 2x PN semiconductor outputs, 1x 2-channel relay output, 20x safe
switchable inputs/PP semiconductor outputs)
For safe speed and/or position acquisition, 1-encoder solutions and 2-encoder solutions are
supported. See "Encoder specifications".
Expansion modules
Central or decentral I/O or axis expansion modules for the PSC1-C-100 series.
A maximum of 8 expansion modules can be connected to a system, of these 6 axis expansion
modules are allowed to be used.
Integrated communication interface
The communication interface has bidirectional data transmission from and to a higher level
controller using a standard fieldbus or safe standard fieldbus.
(1)
For version see: “Optional universal communication interface"