6. CONFIGURATION
27.
5. Depending on the selection (LONG or SHORT) one of two different menus will open (these
menus are the same for the standard cycles), i.e.:
In SHORT mode the following is displayed:
→ S TANDARD DRYING +
FAST DRYING ↑
EXIT ↓
-
In LONG mode the following is displayed:
→ STANDARD DRYING +
INTELL. DRYING ↑
EXTRA DRYING ↓
EXIT -
For the choice criteria, refer to instructions on page 27.
When the CUSTOM program is already present in another position, the selection is
not accepted. The following warning appears on the display, along with a beep:
THIS PROGRAM IS
ALREADY PRESET
CUSTOM PROGRAMS HAVE NOT BEEN VALIDATED AND HAVE NOT BEEN
CLEARED IN THE U.S. BY FDA FOR HEALTHCARE USE. THEY SHOULD ONLY
BE USED BY EXPERIENCED USERS.
PLEASE REFER TO THE “PROGRAM SUMMARY T AB L E” AND ITS GENERAL
NOTES (SEE APPENDIX B – PROGRAMS) FOR THE LIST OF AVAILABLE PROGR A M S ,
THEIR SCREENS AND THE CHARACTERISTICS OF STERILIZABLE MATERIALS (IN RELATION
TO THE PROGRAMS).
THE SELECTION CAN BE CHANGED AT ANY TIME BY FOLLOWING THE PROCEDURE
DESCRIBED ABOVE.
ACCESS TO A CUSTOM CYCLE DOES NOT REQUIRE A PASSWORD.
NONE OF THE COMBINATIONS A V A IL A B LE IN THE CUSTOMIZATION PHASE CREATE ANY
RISKS OR DANGERS OF INJURY TO THE OPERATOR OR DAMAGE TOT HE DEVICE.
To Next Page
Loading...
