Installation
2–2 700-0042 R004
2.1. Installing the EX4 DVR and Lock Box
The EX4 DVR is designed to be installed in the lock box which is secured to the
mounting surface using the screws provided. The lock box can be installed flat on
the floor or under a seat (horizontal installation) or vertically on the floor (vertical
installation), depending on your requirements. The lock box has a removable,
hinged locking door, and a slide rail system to allow for easy installation and
exchange of the DVR.
The EX4 DVR has connections to the front and back of the unit which are secured
once the DVR is installed and the lock box is locked. Cable grommets on the lock
box allows connectors to be inserted into the lock box after installation.
Planning an
installation
Check that you have all the system components and inspect the units for any
scratches or damage. The lock box key is required to unlock the door of the lock
box and remove the components that are placed inside the box for shipping such
as cameras and harnesses.
Materials required You will need these materials to complete the EX4 Basic installation:
•EX4 DVR
• DVR keys for securing the removable hard drive
• Lock box
• Lock box keys for securing the hinged locking door
• Cameras
• Power and ignition harness (3 feet)
• Fuses: 5 A power fuse and 1 A ignition fuse
• Fuse holders
• Butt splice connectors
• Four #10 × ¾" sheet metal screws
• Four #10 × 1" self-drilling screws
You will need these additional materials to complete the EX4 Plus Installation:
• Smart-Link™ module
• Smart-Link-to-DVR connection harness (10 feet)
• Driver’s indicator panel
• Seon video recording label (if purchased)
• Alarm input cable (20 feet)
• Signal harness (3 feet)
• Speed cable (20 feet) (if purchased)
• GPS receiver and cable (if purchased)
• CAN interface cable (if purchased)
Longer cables To customize your installation, longer cables are available by contacting your
sales representative at Seon Design.
To Next Page
Loading...
