Operating the DVR
4–6 700-0042 R004
The Hard Drive power indicator (green) turns off.
4. Lift up on the hard drive tray handle and gently pull out the hard drive.
To install the hard drive:
1. Slide in a hard drive tray until the tray seats inside the front panel.
2. Ensure the handle is lying down against the tray.
3. Insert the hard drive key, turn clockwise by ¼ turn until the drive lock is in the
locked position.
The Hard Drive power indicator (green) illuminates.
4.4. Downloading Video to a PC
Downloading video to a PC is described in the HD Reader User’s Guide
(document part number 700-0036). Please refer to this user guide which is
available online at www.seon.com.
4.5. Extended Operational Functions
4.5.1. Reading CAN messages
Contact Seon Design for assistance in setting up CAN messages for your DVR.
The Smart-Link module requires programming for your specific applications.
4.5.2. Using the ONE-TOUCH Download option
Using the USB port, you can download specific information to a USB drive.
To use the O
NE-TOUCH download option:
1. In the System menu, select the
ONE-TOUCH DOWNLOAD option. See “3.2.10.
Using the System Menu” on page 3–24.
2. Insert a
USB drive into the USB port on the front panel of the DVR.
3. If the DVR is powered off, press the
POWER button for 3 seconds to power up
the DVR.
The red LED on the
MODE button or FULL button illuminates.
OR
4. If the DVR is powered up and recording, press the
STOP button and wait until
the red LED on the
REC button is not illuminated.
ONE-TOUCH DOWNLOAD does not work while the DVR is recording.
5. Press the
ENTER/ONE-TOUCH/8 button.
The DVR downloads the appropriate information to the
USB thumb drive and
the red LED in the
ENTER/ONE-TOUCH/8 button is flashing. When the
operation is completed successfully, the red LED turns off.
To Next Page
Loading...
