Configuring the DVR
700-0042 R004 3–25
Table 3-16
System configuration items
Menu Item Description Values Default
ONE-TOUCH DOWNLOAD Lets you use the ONE-TOUCH
button without a video monitor.
See “4.5.2. U
SING THE ONE-
TOUCH D
OWNLOAD OPTION”
ON PAGE 4–6.
•
ALARMS downloads alarm events
only, starting with the latest
segment and working backwards.
•
TODAY downloads as much
information from today as
possible, starting with the latest
segment and working backwards.
•
TIME downloads as much
information as possible onto the
external device, starting with the
latest segment and working
backwards.
ALARMS
ALARM
BUZZER Set to ON, the buzzer sounds
when an external alarm is
received.
ON, OFF OFF
VIDEO
LOSS BUZZER Set to ON, the buzzer sounds for
30 seconds if a camera signal
goes away while the DVR is
operating.
ON, OFF OFF
DISK
FULL BUZZER Set to ON, the buzzer sounds if
the
REPEAT RECORD option is set
to
OFF and the hard drive is full.
ON, OFF OFF
WATERMARK
VIDEO Set to ON, an undetectable code
is embedded into the video that
can only be seen using a special
viewing application.
ON, OFF OFF
PASSWORD
ENABLE Set to ON, the front keypad is
locked out and requires a
password. Enter the password
while pressing the
FULL button.
To use this function, see “4.5.6.
Using the LOCK Button” on
page 4–11.
ON, OFF OFF
SET
PASSWORD The password is 8 characters. Uses the numbers 0 1 2 3 4 5 6 7 8. 88888888
LOAD DEFAULTS Three sets of default settings are
available that can be changed by
the user.
MEM1, MEM2, MEM3, SEON (factory
default)
Not
applicable
SET DEFAULTS Three sets of default settings can
be changed and saved in the Set
Defaults menu. This means you
can easily call up different
programming features based on
the use of the vehicle.
MEM1, MEM2, MEM3 Not
applicable
To Next Page
Loading...
