Appendix MultiExact Gas Analyser
If a line is not correct a question mark will be placed after it, such as in the
following file:
#######################
# SERVOMEX 1.0
# 2008/12/01 11:46
# 05000A1/00001
# 05000-cu0_13
#######################
#
04000011000400000001E6
04000003000400000002F3
04000013000400000002E3
19000006000442C80000D3
19000007000100DF
19000004000101E1
0E00000000020003ED
0E00000100010AE6
0E000004000100EE
?
0E000003000101ED
0E000002000100EF
1000000700020002E5
10000005000101E9
xxx
If this happens, try sending the file again in case there was noise on the line.
If
the problem continues try down loading the configuration file again from the
original unit.
6. You can connect two units together using a null modem cable. You can then
send the configuration data directly from one unit to the other by setting the
receiving unit to 'load' a configuration and then setting a transmitting unit to
'save' a configuration.
7. Once you have completed the transfer press the tick key on the main form. The
analyser will then restart.
102 05410001A / Revision 6
To Next Page
Loading...
Need help?
General
